. This reverts the programming password and settings to default. Low Battery Override
: The manual is often non-intuitive; requires basic electrical knowledge to wire into a strike or mag-lock system. Made-in-China.com mk098e manual better
* [Old Master Code] # 0 [New Master Code] # [Repeat New Code] # Add User (ID + Card/PIN) * [Master Code] # 1 [User ID] # [Scan Card or Enter PIN] # Delete Specific User * [Master Code] # 2 [User ID] # Set Door Open Time * [Master Code] # 4 [00-99 Seconds] # (Default is usually 5 seconds) Reset to Factory Defaults : Power off the unit, press and hold the key, and power it back on. Key Specifications User Capacity : Supports up to 2,000 users Access Modes : Card only, 4-digit PIN only, or Card + PIN. Durability : Often features a vandal-proof zinc alloy case and is IP68 waterproof for outdoor use. Made-in-China
: Clearly labeled illustrations for the 118x118x22cm unit to help with physical installation. : Clearly labeled illustrations for the 118x118x22cm unit
Most users seeking a "better manual" for this device are looking for clear programming sequences. The unit uses a (Default: 123456 or 999999 ) to enter settings. Programming Command Enter Programming Mode Press ENT 4 times →right arrow Input Master Code ( 123456 ) →right arrow Press ENT Change Master Code In Program Mode: Press 0 →right arrow New 6-digit Code →right arrow ENT →right arrow Repeat New Code →right arrow ENT Add User Card In Program Mode: Press 1 →right arrow Swipe Card(s) →right arrow Press ENT to confirm →right arrow Press 9 to exit Delete User Card In Program Mode: Press 5 →right arrow Input Card Number →right arrow Press ENT Set Door Open Time In Program Mode: Press 9 →right arrow Input Time (seconds) →right arrow Press ENT Factory Reset Disconnect power →right arrow