I dove into the pst file, scrolling through thousands of lines of logic until I found the spindle start block. I had to rewrite the logic to ensure the spindle command was synchronized with the gear selection.

For Y-axis milling on a lathe (or VMC with rotary axes), the 828D uses . This converts Cartesian coordinates (X/Y) from Mastercam into Rotary (C) and Linear (X) movements.

: Includes WORKPIECE output for on-control verification.

A detailed manual explaining how to apply the post's features and use the supported cycles correctly.

Assuming you have a base .pst and .psb file: