: The floor must be level within +/- 5mm over the entire footprint.
The SpeedStile FL rewards attention. Scheduled inspections prevent drift: tighten anchors seasonally, inspect seals and glass for micro-movements, check sensor alignment, and replace consumables before failure. Keep motor firmware and access-control integrations updated with change control and backups.
is typically delivered as a pre-assembled unit but may require lifting gear due to its weight.
Correct alignment is critical for the system's sensors and flap leaves to operate properly.
: Anchor bolts require a minimum depth of 70mm into concrete with a resistance of at least 30N/mm².
Before starting the installation, make sure:
Additional detailed drawings and technical datasheets are available through the Gunnebo Entrance Control official portal.
Gunnebo Speedstile Fl Installation Manual [upd] -
: The floor must be level within +/- 5mm over the entire footprint.
The SpeedStile FL rewards attention. Scheduled inspections prevent drift: tighten anchors seasonally, inspect seals and glass for micro-movements, check sensor alignment, and replace consumables before failure. Keep motor firmware and access-control integrations updated with change control and backups. gunnebo speedstile fl installation manual
is typically delivered as a pre-assembled unit but may require lifting gear due to its weight. : The floor must be level within +/-
Correct alignment is critical for the system's sensors and flap leaves to operate properly. inspect seals and glass for micro-movements
: Anchor bolts require a minimum depth of 70mm into concrete with a resistance of at least 30N/mm².
Before starting the installation, make sure:
Additional detailed drawings and technical datasheets are available through the Gunnebo Entrance Control official portal.